No i deer

Checked my new barrel chambering with the same bullets I was running in my old barrel and I found it was 18 to 20 thousanths shorter. To save any messing I've seated the ammo I had loaded at the shorter length ready for a new seating depth test. The loads were not near the the pressure but the new deeper seating may cause pressures signs..I will try a few and if there are I'll stop..

I use it carefully on my cordless screwdriver to buff the chamber

Sorted 👍

Stainless or chrome moly..? Is it rust or brass deposits from the cases. Does it look a bit spotty looking in through the breech or are you using a borecam to view it more clearly..? Every bore clean I use a 45 cal bisley bronze brush to keep the chambers clean.

I guess you ment 45.2gr not 50.2gr

I would like to swap my tier one low rings for medium rings. Cheers NID

Brownells is cheaper 😁

I didnt realise these rings were so expensive at brownells..

I've just checked by using packers I need 10mm above the top of the of the pic rail to the scope body and half of the scope is 15mm so to have about 1.5mm gap on the objective end so 25mm from the top of the rail too scope centre I think is medium rings. Can you tell what the high rings measure then please.. I think they will be 29mm and the gap is getting too big then.. Thanks for your inputs 👍

I'd be happy to swap them for some TPS mediums. Trouble is I'm unsure if they will be high enough 🙄

Mine are 8 or 9 years old. They been on the same rifle all the time.. 3 different scopes have been mounted in them.

I don't know to be honest.. They were fitted when I had an armalon 308 rifle built. I can give you some measurements later. Rem varmint type profile barrel. 25 or 30 moa rail and the x low were fine with a 56mm sightron scope.. About 1mm clearance

Selling the above rings. Ok condition £40 plus p&p Photo added.

Pm'd you Rick

I've not seen a Roedale stock like your after for sell for quite sometime now.. I've been tempted in the past when I've seen one for sell.

Mongo..!! Who asked you to cherp in you retard 😁. Somebody replied to the thread Saturday so why would I look to check the date.. I was just trying to be helpful 👍

You can shoot out to 1200yds at Bisley on certain days.. No 338s though

My rifles usually have a point of impact change about 1.5 inches at 100yds going from a muzzle brake to a mod and vice versa

Me too 👍

I'm considering RS60 as my new barrel will be sub 24 inches and I could gain 100fps

I've only ever tried one group in my 47 with N150 with 139gr scenars and it was a tight cloverleaf.

Expect the accuracy to have changed switching primers..!!

Thanks Dave . I didn't look at the date 😂

Hi Ian. I know somebody who may want this.. I will find out monday 👍