Pat Allen

Sold I’m afraid !

Bump

For sale Taurus 44mag LBR . Reduced spring trigger and cylinder clearances set by old school pistol smith Gary Clarke . 2 thou cylinder clearance and forcing cone optimised . Will come with std pistol grips and Rosewood grips relieved for quick reloading with supplied 5 maybe 6 jet speedloaders and Hogue holster . Was set up for 1500 comps . Very accurate in right hands . Fitted with Bushnell 1.5 -6 pistol scope . Back injury forces sale and I defy anyone to find a better example with single and double action trigger . Nearly as good as a original S&W special works pistols . £1200 all in . Will be advertised in other places . Pics on request .

Neck turning .

Sent

Hi Andy do you have email as my pics are too big file wise apparently !

K&M micro adjustable neck turning tool . 7mm mandrel £60 posted . Pics on request if needed . 308/284 shell holder

Hi Mark . Seems as though the servers got out of synch somewhere ! But all good now !

Sorry I thought I had ! Will revise post when back at home over weekend

It will be advertised in other sites .

It will be advertised in other sites .

Is anyone after a 30 cal m1 bolt action rifle made by Armalon ? Match trigger , fluted barrel , ph5c ladder sight . ATI stock and with 10/25 rd mags . Excellent condition with less than 500 rds shot. Will come with cases , heads and dies . £1850 . Pm for pictures .

Which model is it ?

I don’t trust any resizing dies and adjust to suite . I’ve tried all the makes and only one that is close is Wilson but still needs adjusting .

Sammi spec is good providing you know your gauges are correct ! It’s all comparative on the precision of your measuring equipment .

Better to start short then move up !

It depends if your looking to resize to your specific rifle chamber as I presumed it was !

You basically wind die in until it seats on shell holder with press at max stroke . Back off about 3/4. Turns . Size case and check measurement required the adjust down until desired shoulder length is hit . Same for all resizer dies basically .

Ok sounds as though your sorted ! 😀

I think as long as it’s consistent then it’s all good . I tend to re size necks 4 thou below after firing then anneal , clean resize body then use mandrel to open necks . Works for me but make sure cases are clean inside . Run my loaded rounds over concentricity gauge and none are more than 2 thou out so whatever your happy with ! 😊

Ok Terry but are you sure you need 2 thou neck tension? I only do mine to 2 though as have a tight neck on my f class rifles . It doesn’t take 5 mins to take the 1/2 though off though 😊

Reloading Solutions sell the Sinclair expander and turning mandrels. They are not custom but expanders are -1.5 thou from nominal and turners -2.5 thou . In both stainless and carbide. I’ve cleaned my stainless 6.5 and 7 mm expanders to -2 thou with fine wet n dry and oil in a drill press.

Lee pot is ok but you’ll need to ditch the thermostat and just regulate it with a digital thermo. Dead easy when you get salts from AC pure . Keep temp to around 520c for great results .

I had a Golden Eagle that didn’t track properly. Swapped for another without question . No issues with replacement

Depends how far you want to shoot with it and what your expecting from the CM ?