baldie Posted August 12, 2015 Report Share Posted August 12, 2015 Finished this last week for a customer. Its a fully blueprinted Rem 700 and was fitted with a Sassen 1 in 8" barrel at 20" Its threaded 18mm x 1 and invisible capped. Trigger will be a Calvin Elite when it comes back from proof. The stock is an Aics AX and i,ve painted the skins to match the metalwork. Custom bolt knob and 20 moa valkyrie rail. Mod is an A-tec Maxim. Paint is Ceracoat mil-spec OD green. Link to comment Share on other sites More sharing options...
Cumbrian 1 Posted August 12, 2015 Report Share Posted August 12, 2015 Very nice Dave, I like the attention to detail regarding the skins. Link to comment Share on other sites More sharing options...
caerhays sniper Posted August 14, 2015 Report Share Posted August 14, 2015 I do love these stock. Not a cheap upgrade though! Link to comment Share on other sites More sharing options...
Shytalk Posted August 25, 2015 Report Share Posted August 25, 2015 Looking foward to receiving it Dave. Top drawer job -yet again. Thanks for all your hard work with it. Link to comment Share on other sites More sharing options...
baldie Posted August 28, 2015 Author Report Share Posted August 28, 2015 Shytalk just sent this. Shot 5 x 3 rounds with a clean in-between, then this 5 round group. The ammo is Factory federal 100 grain soft points. Link to comment Share on other sites More sharing options...
20series Posted August 28, 2015 Report Share Posted August 28, 2015 Shytalk just sent this. Shot 5 x 3 rounds with a clean in-between, then this 5 round group. The ammo is Factory federal 100 grain soft points. Another one of your dodgy builds Dave.... lol I'd say that'll do the biz ok Alan Link to comment Share on other sites More sharing options...
Swarovski1 Posted August 28, 2015 Report Share Posted August 28, 2015 Hi dave, why did this customer go for a 243, I didnt think its much of a tacticool calibre.nothing wrong with a 243, ive had 2 and no complaint, it was more a case of magnumitis, I went for a 25 06, that was a tidy group with out a scope on it Link to comment Share on other sites More sharing options...
Shytalk Posted August 28, 2015 Report Share Posted August 28, 2015 Simple answer is that it suits what I do. I run other tac-driver kit but this is put together for fox, Roe and some vermin work. .243 fits the bill. Dave has worked on all my rifles new and old. Never fails to deliver. Will work up a round to do it justice, add a scope and open my one good eye. Link to comment Share on other sites More sharing options...
justin credible Posted August 28, 2015 Report Share Posted August 28, 2015 Nice gunsmithing but a hideously ugly rifle, but I suppose beauty is in the eye of the beholder. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.