tikka30-06

This is now Sold...

Price reduction £70 posted..

Price reduction £50 posted..

Bump...

Bump...

Thanks Andy 👍

I have this for sale, it came off a Remington Sendero in 7mm Remington magnum that I used for a custom build. It looks like it has had a repair around the rear swivel stud, which has been cut off and replaced further up ( please see photos). Also looks like a bit of damage which has been glued in the same area, still feels very solid though. The aluminium bedding block and pillars are sound. This would make a good stock for rough use on a working rifle. Due to the condition I'm asking for £50 posted. Thanks for looking...

SFS

Hi folks, I have for sale a second hand Howa 1500 short action walnut stock. It is right handed and inlet for a sporter barrel. It has also been glass and pillar bedded. It has a lovely figure and is in pretty good condition, though there is what looks like a natural check ( rather than a crack) in the wood on one side of the pistol grip in the checkering ( see photo ). The stock also has a black fore end tip which I am guessing is a plastic rather than wood but will stand corrected, and 2 sling studs. I'm asking for £70 posted. Thanks for looking

This has now Sold

Bump..Still for sale

Stock still for sale...

Have edited original post to say that the bottom metal is now SOLD, the stock is still available, price adjusted accordingly, hope this is ok

Yeah that would be ok, I'd do it for £65 posted

Hi folks, I have for sale a PSE E-Tac stock for a Remmy 700 Long Action, it is an older version without the spring loading for the adjustable cheek piece, it also does NOT have the adjustment wheel for the cheek piece, this being done by an Allen screw. It was ordered like this by the previous owner so as not to snag on undergrowth while stalking. LOP: 13.5 inches Fittings: 2 flush cups on the side, small section of Picatinny rail on fore end, 1 bipod/ sling swivel stud on fore end. Stock has been recently Duracoated in Highland Green by Geoff at Liquid Steel, there are one or two areas on the forend where the paint has chipped a little due to being taken in and out of the cabinet. Stock has also been skim bedded by Ronin. The bottom metal shown in the photos is NOT included as it has now been sold separately. £535 posted, PayPal preferred, Thanks for looking...

If this is still for sale, is it the Remington Hunter or the McMillan Hunter? Cheers

Hi, is the barrel channel inlet for a varmint or sporter barrel? And is the bottom metal included? Cheers

Looks superb Andy, great work as always mate, looking forward to picking it up this week and trying some 120 gr Ttsx in it, will post a report when I do, thanks again !

Could this be re-inletted for a Rem 700 SA and AICS bottom metal? Cheers

Is this the F1 model?

This is now SOLD...

Hi folks, I have a second hand GRS Berserk stock inlet for a Tikka T3 for sale, Stock is in good condition with a few minor scuffs through use, also comes with QD flush cup swivels, stock is adjustable for comb height and LOP, Looking for £220 posted.. Thanks for looking!

Nice work as always Andy , that stock looks familiar 😉...