Re-Pete

Anyone know if there's a hose available that will allow the gun to be connected to the canister? Would make it easier to set up accurately. The attached canister/gun makes the whole thing a bit unwieldy. RePete

They're 6.5 x 47. The line around the case was down to a dodgy reamer used when I had the barrel fitted. This has now been re-cut properly. Repete

Before anyone says anything, I only clean (ultrasonic) my cases after 5 or 6 firings.........up to then, they just get the neck and primer pocket brushed out before neck sizing with a Lee collet die, and if they need it, a run through a Redding body or type S die. Both these Lapua cases have done 13 firings............. RePete

Here you go............"after" is on the left. Once set up, 50 will take around 10-12 mins.............a bit boring, actually. Might have to design a hopper feed for it............ Re-Pete

Mine arrived today........works fine, is nicely made, and at the price, a no-brainer...............well done Lubo Re-Pete

Here's a pic of a .223 case with a KVB-223 primer. It was the highest of a sequence of five loads of RS52 starting at 1.69 grams, with 0.01 gram increments. Case is PPU, bullet SMK 80 grain Matchking, COL 65.6 mm. Barrel 30", 8 twist. MV was 3140 fps (Magnetospeed). Apart from the volcano, the primer looks OK, still plenty of radius at the edge. RS52 is now my .223 powder............ Dunno why the pic appeared where it did.......... H/man Apologies, this thread seems to have wandered off topic............