Aggy

140 yes everything going just need to pull the home loads 

Need to pull the bullets before I can sell them leave it with me 

1 hour ago, c13thx said:

Pm'd 👍🏽

Replied sold you you 

£75 posted they are currently £110 

Mick 

It’s Hornady never fired but loaded ,would need to pull it prior to selling .

nearly a full tub of viht ,primers ect 

Still for sale and now reduced .

also on gun trader , Also available sound mod brass ,powder ,new magazine etc.

Such a shame these have to stay on ticket it would be an ideal start for a sub 12 build ,as far as I know all the blocks are the same .

The mod would have to be entered onto your fac so an rfd transfer would be the only option with that 

Hi yes it is 

Mick 

Back up for sale ,due to unexpected circumstances 

Sale agreed with Sherlock 

What do you want with the rifle ?

Back with a swap option 

Anyone,Before I stick it on guntrader later 

Hi guys decided to put this up for sale again as it’s just not going to get used ,

mick 

Regardless of barrel design if it fires a bullet then it’s a rile ,shot +shot gun 

I’ve shot one too feels strange you cock it twice and it makes the noise like it should recoil but is just still .

Hello guys question for the barrel gurus amongst us .

I have on ticket a fx impact that is currently throwing pellets out over 1100 FPS and slugs at 1053 in .22 the gun is a fx impact and it uses a smooth twist x liner sat inside an outer tube . As the gun is capable of rimfire speeds wouldn’t it not be a better option to fit a match grade rimfire barrel . 

I have a slot for a .30 barrel too but something 700 mm long that would stabilise lead slugs might be a challenge 

whats your thought 

Pm sent 

I had a pulsar n355 you can have multiple profiles for different cal and rifles ,very good with the right ir 

Got a 6-24 Vulcan I do like it but they are a heavy lump 

Ior 6-24x 56 34mm tube on a 20 moa American defence rail fits but not a huge gap to the rail 

Just received an email. Back from Dave Corbin the uk and Canada are two of the few people he is still exporting too ,and he isn’t recommending using any other presses with his dies as they have too much slop to be repeatedly accurate, tolerance of .001 and a swage pressure of 20.000 psi within the die ,will try and work out what the kit will cost .

just going to the lead to use I have about 200 lb of lead pipe ,diving weights lead shot ect I intended to melt it into ingots first to get most of the muck off and then cast into small cylinders ,holes drilled into a steel bar , to feed the press would this be any good ,it will no doubt have tin or something mixed with it 

In the field laying on the truck bed liner and a lovely day for it too 

Everything shot should  be part of the group good or bad ,