chaz Posted December 8, 2022 Report Share Posted December 8, 2022 Hi folks, although I own several case trimmers, I do like my Forster with the Chamfer and De-bur head on it. The only issue I have nowadays, is due to my disabilities..... I find it hard and painful to hand crank continuously if I have say 50 pieces of brass to do. I have all sorts of bits lay around in my garage, so I could easily knock out an attachment to the trimmer handle then a bit of flexible pipe to a small cordless screwdriver i have. The only thing I could do with is the size of the shaft thread, once the handle is unscrewed off. I think it may be 9/16 by 24. But I would really appreciate it if somebody could confirm this, or tell me what the thread pitch is? Constructive advice appreciated. Cheers Chaz. Quote Link to comment Share on other sites More sharing options...
chaz Posted December 8, 2022 Author Report Share Posted December 8, 2022 Thanks Bolte. Much appreciated. 👍 Quote Link to comment Share on other sites More sharing options...
Scotch_egg Posted December 9, 2022 Report Share Posted December 9, 2022 Where is Bolte’s reply? Quote Link to comment Share on other sites More sharing options...
bolte Posted December 9, 2022 Report Share Posted December 9, 2022 Pm,d Quote Link to comment Share on other sites More sharing options...
chaz Posted December 9, 2022 Author Report Share Posted December 9, 2022 Anyone else have the definite shaft size of the Forster trimmer shaft that the hand cranking handle screws on to.?? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.