joshmartin8 Posted April 27, 2015 Report Share Posted April 27, 2015 after some advise from a close friend of mine he has had great results with a new bullet he has been using, so after tracking some down i went and picked up a box, these bullets have been designed and have performed very well in remaining stable through the transonic and into subsonic zones and remain accurate, i am hoping to get them out at around the 2700 if possible, will report on load development later on Link to comment Share on other sites More sharing options...
jay666d Posted April 27, 2015 Report Share Posted April 27, 2015 I've always had good loads with Bergers, albeit in .223... Never the less they made the best of my 1in9 twist and got rounds on target at 1000 yards. Link to comment Share on other sites More sharing options...
joshmartin8 Posted May 14, 2015 Author Report Share Posted May 14, 2015 i did pu up the results the other day of group size and velocity on another section, but here were the results from these the other day , 2750fps, slightly getting pressure signs but ok to deal with and not hammering the brass to bad, 200 yard group 300yard group - Link to comment Share on other sites More sharing options...
joshmartin8 Posted May 14, 2015 Author Report Share Posted May 14, 2015 looking to push these out onto a 600yard target next week to confirm velocity and drop data, then out to the magic 800 on gongs, Link to comment Share on other sites More sharing options...
Swarovski1 Posted May 14, 2015 Report Share Posted May 14, 2015 Hi Josh what's your rig and what are you loading these juggenaults with, them groups are very impressive at 2 and 300yds, atb swaro Link to comment Share on other sites More sharing options...
joshmartin8 Posted May 14, 2015 Author Report Share Posted May 14, 2015 Hi Josh what's your rig and what are you loading these juggenaults with, them groups are very impressive at 2 and 300yds, atb swaro thanks swaro, i have an Accuracy international AE MK111, I am using 46g of viht n150 and they are seated 10'' off the lands, I get similar results with 155grain lapua scenar and 155g amax, again 46g of Viht 140 this time, also 10'' off the land, I am experimenting with 178 amax at the min and these are also coming in with ragged holes which is making be start to believe my barrel is a bit of a prostitute and goes well with everything Link to comment Share on other sites More sharing options...
jay666d Posted May 14, 2015 Report Share Posted May 14, 2015 Very impressive groups! :-) Link to comment Share on other sites More sharing options...
Swarovski1 Posted May 14, 2015 Report Share Posted May 14, 2015 Probably around 18lb rig with bipod and mod on,its a good heavy platform, accuracy internationals have good barrels on from the factory, whats the barrel length and twist,cant say ive ever seen 300yd groups like that, ive had sub inch 5 shot group at 300yds,ive once had 4 shots into 0.6 oai and let the 5 go a bit, still got the target, not one holers like you have posted, I have done a 3 shot group with 140gr amaxs at 450yds that was 35mm, maybe lucky but I did it, a bloke in my club uses 185gr juggs and he runs his at 2550fps on a 26 inch armalon tube, he seats with micrometer and they dont like compressed loads so say so his are down on powder, thinks he uses n560,at 2750fps from a 26 inch tube is pushing the 185s fast, didnt know that was possible, I run 168gr amaxs at 2750fps on 44.8grs of n150, Link to comment Share on other sites More sharing options...
joshmartin8 Posted May 14, 2015 Author Report Share Posted May 14, 2015 Probably around 18lb rig with bipod and mod on,its a good heavy platform, accuracy internationals have good barrels on from the factory, whats the barrel length and twist,cant say ive ever seen 300yd groups like that, ive had sub inch 5 shot group at 300yds,ive once had 4 shots into 0.6 oai and let the 5 go a bit, still got the target, not one holers like you have posted, I have done a 3 shot group with 140gr amaxs at 450yds that was 35mm, maybe lucky but I did it, a bloke in my club uses 185gr juggs and he runs his at 2550fps on a 26 inch armalon tube, he seats with micrometer and they dont like compressed loads so say so his are down on powder, thinks he uses n560,at 2750fps from a 26 inch tube is pushing the 185s fast, didnt know that was possible, I run 168gr amaxs at 2750fps on 44.8grs of n150, tell me about it mate i am over the moon with the results, i probably am giving the brass a little pasting but they are only marking on a couple and not to bad either, the groups .2 and .4 above were worse as you can expect but thats why i was happy to run with the 46g load, it is a 1in11 twist and its a 24inch thats why I'm even more surprised on velocity which i am over the moon about, yes it is a bledy heavy platform but i love it, think they are going to be an amazing load for the extended ranges when i can eventually get out there. Link to comment Share on other sites More sharing options...
Swarovski1 Posted May 14, 2015 Report Share Posted May 14, 2015 My remy 308 in aics stock is probaly near 17lb with bipod and mod on.i think the ft boys run there 185gr jugs at around 2800fps in there looong barrels.you should get very good results out to 1000yds at them velocities with the 0.560 bc.laurie sez they are outstanding bullets.if I could achieve them speeds I would change over.ive been threatening to try the 155.5s and the 185s but I've not got there yet.i am going to have too after this thread.oh are you single feeding these or do they just fit in your mag Link to comment Share on other sites More sharing options...
joshmartin8 Posted May 14, 2015 Author Report Share Posted May 14, 2015 My remy 308 in aics stock is probaly near 17lb with bipod and mod on.i think the ft boys run there 185gr jugs at around 2800fps in there looong barrels.you should get very good results out to 1000yds at them velocities with the 0.560 bc.laurie sez they are outstanding bullets.if I could achieve them speeds I would change over.ive been threatening to try the 155.5s and the 185s but I've not got there yet.i am going to have too after this thread yeah i must be really lucky i think, don't know how I'm doing it , will update this thread when i have stretched out and trued my drop data at 800, yeah give it a go mate ben if ya can achieve 2700it will be a bonus Link to comment Share on other sites More sharing options...
Swarovski1 Posted May 14, 2015 Report Share Posted May 14, 2015 I just put 46grs of n150 in a 308 case.it comes halfway up the neck.i would say that's fairly compressed Link to comment Share on other sites More sharing options...
joshmartin8 Posted May 14, 2015 Author Report Share Posted May 14, 2015 I just put 46grs of n150 in a 308 case.it comes halfway up the neck.i would say that's fairly compressed yeah i do use a long drop tube bit it is a little i think, i am seating them bledy long to be fair Link to comment Share on other sites More sharing options...
joshmartin8 Posted May 14, 2015 Author Report Share Posted May 14, 2015 just looked think i got my group pics the wrong way round, but there aint much in either of them Link to comment Share on other sites More sharing options...
Swarovski1 Posted May 15, 2015 Report Share Posted May 15, 2015 I just watched a video on utube somebody shooting there 308 using 185gr juggs at 1760yds, it didnt say what 308 or barrel etc, Link to comment Share on other sites More sharing options...
joshmartin8 Posted May 15, 2015 Author Report Share Posted May 15, 2015 I just watched a video on utube somebody shooting there 308 using 185gr juggs at 1760yds, it didnt say what 308 or barrel etc, yes mate they are an epic round i believe, yet to try them myself at range but will be reporting back as soon as i do Link to comment Share on other sites More sharing options...
joshmartin8 Posted May 17, 2015 Author Report Share Posted May 17, 2015 only managed to get out to 360 today due to terrain but still can't get over the results these things are producing, 3 shot 5.5 moa. and .25 for wind Link to comment Share on other sites More sharing options...
Swarovski1 Posted May 17, 2015 Report Share Posted May 17, 2015 Seems as if you have found the dream load,3 shot 0.5 inch group at 360yds is very good Link to comment Share on other sites More sharing options...
joshmartin8 Posted May 17, 2015 Author Report Share Posted May 17, 2015 Seems as if you have found the dream load,3 shot 0.5 inch group at 360yds is very good yes i believe i have, thanks swaro, looked at all the brass today and can't see any extractor marks at all just slightly flattened primers so I'm over the moon now, safe load for warmer weather also, Link to comment Share on other sites More sharing options...
Swarovski1 Posted May 18, 2015 Report Share Posted May 18, 2015 Does the brass flow only happen on one occasion only in the cases life span from a hot load or will it do it every hot load.sure I heard someone say it only happens once.not sure really doh. Link to comment Share on other sites More sharing options...
joshmartin8 Posted May 18, 2015 Author Report Share Posted May 18, 2015 Does the brass flow only happen on one occasion only in the cases life span from a hot load or will it do it every hot load.sure I heard someone say it only happens once.not sure really doh. no it will happen all the time if the load is too hot, if the case is in a different position you will seed the ejector mark somewhere else if its hot, Link to comment Share on other sites More sharing options...
Swarovski1 Posted May 20, 2015 Report Share Posted May 20, 2015 Josh maybe you should try the egg shoot with you berger load Link to comment Share on other sites More sharing options...
Offroad Gary Posted May 20, 2015 Report Share Posted May 20, 2015 That rifle won factory class in the egg shoot with 155 scenars, spanked a few race guns too... Link to comment Share on other sites More sharing options...
Swarovski1 Posted May 20, 2015 Report Share Posted May 20, 2015 With them 185s shooting like gar he would be in for a shout,thumb nail group at 360yds Link to comment Share on other sites More sharing options...
joshmartin8 Posted May 21, 2015 Author Report Share Posted May 21, 2015 With them 185s shooting like gar he would be in for a shout,thumb nail group at 360yds would love to but i have a wedding on that day i have to go too, gutted, if there anything else popping up you guys think i be interested in please let me know Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.