dannyt Posted September 20, 2011 Report Share Posted September 20, 2011 Right i need a bit of help tracking down an action tenon drawing for a Bat Multi flat MB action Ive email Bat Machine NO answere .Has any body got one they could email or send to me. I would like to know the clearance between the bolt face and barrel ? and the degree angle to cut the barrel face . thanks Danny Link to comment Share on other sites More sharing options...
garyw Posted September 20, 2011 Report Share Posted September 20, 2011 Right i need a bit of help tracking down an action tenon drawing for a Bat Multi flat MB action Ive email Bat Machine NO answere .Has any body got one they could email or send to me. I would like to know the clearance between the bolt face and barrel ? and the degree angle to cut the barrel face . thanks Danny DANNY- ring PETER WALKER or pm VINCE AKA gun pimp he will know im sure Link to comment Share on other sites More sharing options...
taylor Posted September 20, 2011 Report Share Posted September 20, 2011 25 degree cone bolt and i aim for 7 thou clearence ,dont have a drawing - Link to comment Share on other sites More sharing options...
dannyt Posted September 20, 2011 Author Report Share Posted September 20, 2011 thanks for the info fellas, Ive put a program in my machine and just needed to make shure it was ok. Danny Link to comment Share on other sites More sharing options...
Ronin Posted September 20, 2011 Report Share Posted September 20, 2011 1.125" Tenon 16 Tpi. Cut tenon to headspace of bolt face. You will need to trim back .050" before the barrel sits snug to the action face... Then 25 degree cone, cut back untill you can measure final fit to face of action with feeler guages. I use .005" clearance.... Just done an MB round action ....... Hope that helps. Link to comment Share on other sites More sharing options...
dannyt Posted September 21, 2011 Author Report Share Posted September 21, 2011 Again thanks for the info Ronin. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.