Jump to content

neumo

Members
  • Posts

    29
  • Joined

  • Last visited

Everything posted by neumo

  1. Time for another clean out of unused bits, so here is my Leupold VX2 3-9 x 50 scope. This is a 1” tube scope with the LR Duplex reticule, which has a cross hair with 2 dots below it, with ¼ MOA adjustments. The scope was used very little & is in good condition with a couple of faint marks on it from mounting. Comes in box with Manuals. £160 posted by RMSD
  2. This has the following reticule: Ring with 1 Dot The most popular reticle offered, this 68 MOA ring with 1 MOA dot is ideal for fast target acquisition. It provides three usable aiming points. The aiming points below were based on the following load: .223 Cal. 62 Gr. 2,900 Vel. Other loads and calibers can also be used but the operator will have to establish the ranges associated with the aiming points. When using a shotgun, the 68 MOA ring can be used to represent shot patterns but will vary based on choke and shell selection. 7 yards (close range) 50 yards (medium range) 200 yards (medium range)
  3. This was built in 2017 and I have had it for a couple of years. I used it a bit for practical rifle but it has only been used a few times.
  4. Here for sale is my EOTECH EXPS3, which is the Extreme version of the industry standard Eotech. Has the dot & ring reticule and this one has the NV modes built in. Has built in BDC for .223, built in Weaver/picatinny mount. Comes with box and paperwork. Was used a bit on my .22 Smith but changed it out for a MRO, that I liked better. Details of the spec can be found here: https://www.tactical-kit.co.uk/eotech-exps3-0-night-vision-compatible-holographic-weapon-sight---tan-19274-p.asp £450 posted or can deliver to Bisley
  5. ** Both Mags & the stock are now SOLD ** Here is my old 308 kit I used for CSR before I bought a straight pull. It consists of the following: MDT Light Sniper System (LSS) Chassis for Remington 700 (Short action) - Folder: MDT LSS Stock in Black, that takes AICS Mags. Has some ware marks on it (see photos) Carbine buffer tune with MDT Folding stock adaptor Basic AR butt Pad and a Hogue rubber grip Full spec & prices for stock is here: https://www.blackrifle.co.uk/MDT-LSS-Chassis-p/mdt-lss.htm PLUS 4x 10 round .308 AICS Magazines, with basic battle belt & 4 pouches for Mags Would cost over £600 to replace. I am not looking to split the Mags at this time, unless I get an offer on the stock first. Would make a good cerakote project. Looking for £400 posted by RMSD or can deliver to BIsley
  6. Here for sale is a used Vortex Strike Eagle 1-6 x 24 scope. It is 2nd focal plane. Comes with font & rear plastic flip up caps; this one does not have a box or manual, so is scope only. The specs are: - 30mm tube - ¼ MOA adjustments - Parallaxed to 100 yards - BDC reticule for .223 / .308 with Illumination Details can be found here: https://www.opticswarehouse.co.uk/product/vortex-strike-eagle-1-6x24-illuminated-ar-bdc-riflescope/ £210 posted or can deliver to Bisley (but on holiday at the end of October)
  7. Remington 700 in .308 Boyds Stock Here is a Remington 700 in .308 that I bought as a stalking gun but ended up not using very much. It has a 16” barrel that is threaded for M14x1 with a well done ‘invisible’ thread protector has a Picatinny rail on top. The action is ceracoated in a dark grey and had a trigger job done by a well known rifle smith. Comes in a grey Boyds stock & has a few small marks from the field & cabinet storage. I have put about 500 rounds through it and it had had about the same when I bought it. A good solid cheap rifle for someone. Now £550 ideally face to face transfer in the Guildford area or 1 hour from there Tikka T3 synthetic stock in .243 with 1” optiloc rings Good solid Tikka T3 synthetic stock in .243, with thinner barrel & screw cut for M14x1 can, with a thread protector. Has a set of medium 1” optiloc rings and the standard flush magazine. Has a few small marks from the field & cabinet storage nut is in good condition. I have a picatinny rail for this if the Optilocs don't work for you. Now £600 ideally face to face transfer in the Guildford area or 1 hour from there
  8. I have a couple of red dots to sell to help fund a new rifle. EOTECH Holographic Red dot - EXPS3-0 version with NV modes This is the Extreme version of the industry standard Eotech. Has the dot & ring reticule and this one has the NV modes built in. Has built in BDC for .223, built in Weaver/picatinny mount. Comes with box and paperwork. Was used a bit on my .22 Smith but changed it out for a MRO, that I liked better. Details of the spec can be found here: https://www.tactical-kit.co.uk/eotech-exps3-0-night-vision-compatible-holographic-weapon-sight---tan-19274-p.asp £500 posted or can deliver to Bisley Shield MiniSight red dot – 1MOA dot with 65 MOA ring Original shield MiniSight, with 1MOA dot with 65 MOA ring. Comes with Picatinny base mount, adjustment tool, Instructions. Hardly used and a good solid Red Dot £120 posted or can deliver to Bisley
  9. Price drop for Christmas... Vortex Crossfire2 Hog Hunter 3-12 x 56 - Vbrite MOA Dot reticule ** SOLD ** Schmidt & Bender 8x Hungarian 1” tube Standard Hungarian S&B 8 power deer scope, German style cross hair. Bought for stalking but hardly used. Comes with elasticated lens cover. Couple of small marks from use or storing in cabinet. £250 posted or can deliver to Bisley
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy