T3_tinker Posted July 4, 2021 Report Share Posted July 4, 2021 So I recently started putting my fired brass through a fl sizing die without the expander ball so to bump the shoulder and tighten the neck then put the case into an expander mandrel for the correct neck tension. After my last batch of 50 cases I had 3 that the mouth was flared right out at the end, one to the extent that it was almost rolled over. Any thoughts? Quote Link to comment Share on other sites More sharing options...
Popsbengo Posted July 4, 2021 Report Share Posted July 4, 2021 I suspect the expander mandrel is set too deep and the shoulder is impacting the neck on full stroke Quote Link to comment Share on other sites More sharing options...
T3_tinker Posted July 5, 2021 Author Report Share Posted July 5, 2021 Ah ok that makes sense! Quote Link to comment Share on other sites More sharing options...
gunner Posted July 9, 2021 Report Share Posted July 9, 2021 yeah you must be bottoming out the case mouth on the mandrel holder ? Case Solved ?? lol atb Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.