Jump to content
UKV - The Place for Precision Rifle Enthusiasts

Recommended Posts

So, thinking one of the first posts a request usually isn't very successful, I hope you gentlemen (and ladies) prove me wrong.

I have an old Sako TRG-S/M995 that when I bought it was in dire need of a new barrel. It became a "project" since I wasn't in need of another to use right away (I have a few others).

Finally settled on a 26" Krieger Remington Varmint 1:7 280AI, but since Covid-19 severely delayed shipping (9 months now still waiting) thoughts about a chassis for this heavy hunter/target/long range arose.

Then i found this used TRG42 stock...

And now the request:

The 42 stock does not have a trigger housing/mag catch so I need to manufacture one. Could you please provide me with measurements for A-M in the picture below?

 

TriggerGroupMeasurements.jpg

Share this post


Link to post
Share on other sites
1 hour ago, Scotch_egg said:

Consider a trigger guard from KRG. I used one on my TRG stock that I used for a Tikka T3. 

Thank you!

I have done just that but has not been able to find one sold separately in their online store (and would not that also mean that I would have to use AICS magazines?). I suppose I should have sent KRG a mail, since they always seem very helpful, but I was given an estimated delivery time of six months on any KRG product when asking a local dealer (and local means 300+ miles away). I am hoping to have this project done sooner than that.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy