CerebralDistortion

Thank you! I have done just that but has not been able to find one sold separately in their online store (and would not that also mean that I would have to use AICS magazines?). I suppose I should have sent KRG a mail, since they always seem very helpful, but I was given an estimated delivery time of six months on any KRG product when asking a local dealer (and local means 300+ miles away). I am hoping to have this project done sooner than that.

So, thinking one of the first posts a request usually isn't very successful, I hope you gentlemen (and ladies) prove me wrong. I have an old Sako TRG-S/M995 that when I bought it was in dire need of a new barrel. It became a "project" since I wasn't in need of another to use right away (I have a few others). Finally settled on a 26" Krieger Remington Varmint 1:7 280AI, but since Covid-19 severely delayed shipping (9 months now still waiting) thoughts about a chassis for this heavy hunter/target/long range arose. Then i found this used TRG42 stock... And now the request: The 42 stock does not have a trigger housing/mag catch so I need to manufacture one. Could you please provide me with measurements for A-M in the picture below?

I feel... envy. 😁

Just to offer a different perspective... Shoot then go home. 4-5 patches wet with Ed's red. A 5-10 minute pause between patch two and three. 2 dry patches and one final with Ed's for corrosion protection, not as wet as the first five. Sweets 7.62 every thousand rounds or if/when the dry patches don't run smooth and even through the bore. Not on a Tikka, but on a couple of Sakos and Sauers.