Deeredriver Posted April 8, 2019 Report Share Posted April 8, 2019 I'm thinking of acquiring a 6mm barrel for my AI AT. Does anyone know or have any experience with using a 6mm Dasher from this set up or from the AI AW magazines, i.e. Double Stack Double Feed? My concern is that maybe the case will be a little short to feed 100%. I don't want to have to modify mags. Link to comment Share on other sites More sharing options...
justin credible Posted April 8, 2019 Report Share Posted April 8, 2019 I will stand corrected but I believe that you do have to modify the mags to get them to feed reliably. Baldy on here did the conversion for my AI mags to feed 6br. They work flawlessly. Link to comment Share on other sites More sharing options...
baldie Posted April 9, 2019 Report Share Posted April 9, 2019 I ran a little experiment recently. Chambered and old scrap of barrel [just a chambered stub really ] in 6mmBr and screwed it onto an AX. The double stack mags fed it reliably. It also extracted an empty case properly. Folk make that mistake with little cases, they think because it will pull a dummy round out, it will work with a fired case.....not always. Link to comment Share on other sites More sharing options...
Malinois Posted April 9, 2019 Report Share Posted April 9, 2019 Baldie. If you adapt them will they still feed other cases? Link to comment Share on other sites More sharing options...
baldie Posted April 9, 2019 Report Share Posted April 9, 2019 Not with you Ian ? If you mean the AICS 10 rd single stack mag, then , yes they will. Its a replacement spring, follower and spacer. They can be removed, and the original put back, in about a minute. The double stack AW/AX mag, doesn't need converting. The AICS, once converted will feed all the ducky little cases such as 6mmBr, Valkyrie, even PPC. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.