DaveT Posted June 23, 2018 Report Share Posted June 23, 2018 Just tested one of these in 260 Rem. Makes homing in on setback a breeze. You still have the coarse setup ....thread it down and then back off a tad...but after that SO much easier than the standard screw it in a bit and see if it gives the right sizing...repeat until you overshoot and push it back too much! Easy detent clicks after initial coarse setup give precise half thou incremental shoulder pushback on newly annealed Lapua brass...I think their website says .001" per click but I get half that. Brill quality dies...I will be getting other calibres to replace my current FLS set. Link to comment Share on other sites More sharing options...
Catch-22 Posted June 23, 2018 Report Share Posted June 23, 2018 That's pretty cool. I have a couple of their standard FL die sets and I do think the dies are really good. I did think some of the external finish to be a bit so so, but the actual sizing result is top notch. Link to comment Share on other sites More sharing options...
BobSki Posted September 20, 2018 Report Share Posted September 20, 2018 Dave where did you get yours from please? Link to comment Share on other sites More sharing options...
jcampbellsmith Posted September 20, 2018 Report Share Posted September 20, 2018 https://www.whiddengunworks.com/wgw-products/ Regards JCS Link to comment Share on other sites More sharing options...
BobSki Posted September 20, 2018 Report Share Posted September 20, 2018 oh bugger, I thought you were going to say somewhere local to the UK LOL Link to comment Share on other sites More sharing options...
DaveT Posted September 20, 2018 Author Report Share Posted September 20, 2018 They do mail them at minimal cost. Link to comment Share on other sites More sharing options...
BobSki Posted September 20, 2018 Report Share Posted September 20, 2018 Cheers Dave Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.