KRG Bravo modification

[SMLE]

If any of you with a KRG Bravo stock who are as frustrated as I was by the cheek riser not locking into a fixed position and the accepted fix being o rings on the pillars; you might be interested in my quick fix.

I established the riser height and measured the gap above the stock body.

I then cut the neck off two .303 cases to the depth of the dimension above (the .303 case is almost the same size as the pillars).

Then I split the case neck down it’s length to create a sort of “collet” and slipped one onto each pillar.

They are a snug fit and hold the riser in exactly the correct position each time.

I used a junior hacksaw and a file to smooth them off after cutting, but those with a dremmel might be able to whizz a couple off a lot quicker.

Plus, they add a bit of bling.... ?