T3 Atlas AICS inlet

[mam's 'lil soldier]

Has anyone put an Atlas AICS bottom metal into a factory T3 stock as I have a question before I break out the router of doom, ??.......?.... As my local Smith isn't taking on any new work at present and I haven't got time to be traveling about I thought I'd have a go. What's the worse that can happen? ???

Can I inlet the stock so the bottom metal is flush or do I set it to standard height so the metal is flush by a few mm's? My measurements indicate flush but I've not done one of these before so could do with an encouraging nudge.

I know I can set the mag height by attacking the mag release but would prefer to know I'm in the ball park first.

Cheers in advance.

[baldie]

this is for the mags I sent you ?

If you want the job doing quickly, I can fit it in ?

If you want a go yourself, give me a buzz in the morning.

Mag height is fairly critical on a .223 as there is not much case base for the bolt to engage.

[mam's 'lil soldier]

Cheers Dave,

I'll bell u in a bit.