kaduflyer Posted October 2, 2017 Report Share Posted October 2, 2017 anyone have any expierience with case trimmer and neck uniformity i was looking for a trimmer that can do both after looking for seems ages its hard to make decision on what kind so expierience is the best way to go any ideas Link to comment Share on other sites More sharing options...
VarmLR Posted October 3, 2017 Report Share Posted October 3, 2017 Don't know if this is exactly what you mean but I achieve this (improved neck uniformity and case trimming) but in two steps. After annealing and FL sizing, I use a Wilson/Sinclair case trimmer like this one: A micrometer gauge can be used to determine neck run-out with the case still sat in the Wilson case holder as it's easy to turn holder around (once unclamped) on the rails. If there is a batch that seems too high, The Lee Collet Neck sizer can be used which seems to bring an improvement to neck uniformity, but I don't turn the necks themselves to uniform brass thickness. If it varies by much, the brass can simply be batched. Link to comment Share on other sites More sharing options...
Martin52 Posted October 4, 2017 Report Share Posted October 4, 2017 I have the Wilson and it will hold trim length to 0.001 case after case. If buying again, I would consider the Forster with the 3 in 1 attachment. Martin Link to comment Share on other sites More sharing options...
1967spud Posted October 4, 2017 Report Share Posted October 4, 2017 hi give us pm if you need a chat regards these Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.