hunter686 Posted April 28, 2017 Report Share Posted April 28, 2017 I'm about to send away a dummy round to my smith to set the freebore on my new wildcat. I just wanted to get a second opinion to make sure that heal of the bullet is avoiding the doughnut zone. Thanks in advance Link to comment Share on other sites More sharing options...
onehole Posted April 28, 2017 Report Share Posted April 28, 2017 I would say your pushing it ,,,,I,m used to tight necks and potential donut forming,,,,,,,pretty sure you will be feeling a donut especially when you load off lands,,,,you really don't want a donut in a tight neck,,,,,you got a long neck there,,,,take some advantage of it,,,,regds ,,,,O Link to comment Share on other sites More sharing options...
hunter686 Posted April 28, 2017 Author Report Share Posted April 28, 2017 I would say your pushing it ,,,,I,m used to tight necks and donut forming,,,,,,,pretty sure you will be feeling a donut especially when you load off lands,,,,,you got a long neck there,,,,take some advantage of it,,,,regds ,,,,O Thanks man, i was thinking it was on the close side. My neck is 0.333 bullet is loaded to 2.934 mag allows 2.980 so i still have a good bit to go but would still like to leave room to chase the lands. Bullet is a 140 eld fyi Link to comment Share on other sites More sharing options...
onehole Posted April 28, 2017 Report Share Posted April 28, 2017 Cant quite make out if your neck turning or not?,,,top pic shows you are??,,,,in any event a good bite into the shoulder will reduce potential of a donut,,,,best to turn a bit anyways,,,,O Link to comment Share on other sites More sharing options...
hunter686 Posted April 28, 2017 Author Report Share Posted April 28, 2017 Cant quite make out if your neck turning or not?,,,top pic shows you are??,,,,in any event a good bite into the shoulder will reduce potential of a donut,,,,best to turn a bit anyways,,,,O I am turning. I use the KandM with cutter pilot. That's the only reason i never cut into the shoulder but will when i get my lapau stuff on the go. This is just scrap brass Link to comment Share on other sites More sharing options...
hunter686 Posted April 28, 2017 Author Report Share Posted April 28, 2017 Here is an extras 20tho (2.954) Link to comment Share on other sites More sharing options...
onehole Posted April 28, 2017 Report Share Posted April 28, 2017 Oky doke,,,,,,you really really don't want a donut,,,,take care,,,,,,,O Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.