spartan7510 Posted June 11, 2017 Report Share Posted June 11, 2017 I have kinetic bullet puller. Pulled a couple - circa 10 from a reload that went wrong (REDDING DIES - I get onto that later). The ogive on my rifle is 2.223" . Prior to pulling these was fairly consistent. These are Lapua Scener 155gr .30 cal - so good bullet heads in my opinion. after I measure them again without adjustment I was getting 2.210". Using a brand new bullet (not pulled) on same die and setting still provided 2.223" any one else seen this? Is there any potential the bullet head had been distorted some what after crimping and pulling? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.