munkjack Posted May 1, 2016 Report Share Posted May 1, 2016 Hi does anyone no were I can get some pillars for bedding a Cz 455 Cheers. Link to comment Share on other sites More sharing options...
NoEntry Posted May 2, 2016 Report Share Posted May 2, 2016 I used these on my 452 they worked fine. http://www.lampspares.co.uk/steel-10mm-allthread-75mm-long-hollow-rod-ei2075-plu85962/ mike Link to comment Share on other sites More sharing options...
munkjack Posted May 2, 2016 Author Report Share Posted May 2, 2016 Great looks good how did you cut them to size? as I'm guessing that's the tricky bit getting a perfectly flat surface to alighn the action. Link to comment Share on other sites More sharing options...
NoEntry Posted May 2, 2016 Report Share Posted May 2, 2016 Measure twice cut once, I used my digital verniers to measure. I made mine very slightly overlength and carefully filed them down. Theres loads of info on the internet re pillar bedding the CZ. Mike Link to comment Share on other sites More sharing options...
munkjack Posted May 2, 2016 Author Report Share Posted May 2, 2016 Did you cut a notch out the rod to fit the magazine well? Link to comment Share on other sites More sharing options...
NoEntry Posted May 8, 2016 Report Share Posted May 8, 2016 I used my Demel and ground one side of the pillar to give the necessary clearance. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.